Vapcell 14650 V11 1100mAh 6A batteries
$10.99 (лот 2шт)
Yes, I received a fairly large package from Vapcell not long ago. They even sent more types of batteries than I ordered, but unfortunately they didn’t send the ones I wanted most and have been asked about several times. I’m talking about the K64, 26650 cells with a fantastic capacity of 6400 mAh. When I asked the Vapcell manager about them, I was told they’d run into technical difficulties, and it’s not clear whether the cells will be available at all :(

Personally, I was interested in the 14650 batteries, so I decided to start testing those. And yes, don’t ask me where these are used—I have no idea. I’m interested in them simply because of their unusual size :)
By the way, there’s the same listing with paid shipping, and for some reason it has a lot more buyers and even some reviews - link.
They come in a plastic case, and the packaging looks neat.

The specifications are listed on the Vapcell website, but for some reason the battery type was misidentified in the name: it said H10 instead of V11.
Typical Capacity: 1100mAh (0.2C discharge)
Min capacity: 1050mAh (0.2C discharge)
Nominal voltage: 3.60V
Max Continuous Discharge Current: 6A
End-of-charge voltage: 4.20V
End-of-discharge Voltage: 2.5V
Weight: 28g ( Appr)
Internal resistance: 18mΩ ( Appr)(AC 1kHz)
Standard Charge: 500mA,CCCV 100mA cut-off
Quick Charge Current: 1500mA
As you can see from the specs, these batteries don’t stand out in any particular way. Their capacity is comparable to good 14500 cells, and the maximum current is rated at just 6A.
They’re wrapped in yellow heat-shrink tubing and have an authenticity-check code. The positive terminal is flat, almost flush with the end.

Their dimensions are right in line with the stated 14650 form factor: 65 mm long and 14 mm in diameter.
They weigh a little over half as much as 18650 batteries, so they’re at a significant disadvantage in terms of energy density by weight.

The batteries arrived almost fully charged; the first charge cycle took just 270 and 238 mAh.
The conditioning cycle showed a very respectable capacity, noticeably higher than the rated value—a difference of more than 10%.

According to the description, the batteries support two charging modes: standard at 0.5A and fast at 1.5A. It’s odd that the standard charge current isn’t specified relative to capacity; at 0.55A, it would be exactly 0.5C.
In standard mode, a full charge took 2.5 hours, which is pretty good.

At 1.5A, the battery took almost an hour to charge. The CV phase lasted noticeably longer, but the result was still good.

Testing was carried out in 7 modes: 0.2, 0.5, 1, 2, 3, and 4C, plus 6A, where C = 1.1A. I also wanted to test at 10A, but the 6A test showed that there was no point.
The battery performs very well up to 4C, delivering 1245 mAh or 4.578 mWh at 0.2C, which exceeds the rated specs.
But at 6A, the battery suddenly “gave up,” delivering just 807 mAh.

The temperature was within normal limits. Below are the results at 3C and 4C, as well as at 6A. At the maximum current, the battery simply didn’t have time to warm up.

The second sample performed slightly worse, but still exceeded the rated specs and likewise couldn’t handle 6A.

The temperature results are similar to those of the first sample.

A comparison graph of the first sample (blue) and the second (red) at 0.2C, 1C, and 3C, and at 6A, also shows the second sample lagging behind. The small difference becomes noticeable when discharging at 6A.

The Vapcell website includes a discharge graph from a well-known Danish website. The discharge modes differ from mine, but the overall picture is the same.
By the way, I noticed again that his capacity results are slightly lower than mine. The last time I compared them, I could put that down to the different cutoff voltage, but in this case, because the voltage drops sharply at the end of discharge, the difference is still there even with that taken into account. Strange, but I'm sure about my tester.

As usual, here are the battery impedance measurements taken after receiving them, after "conditioning," and after all the tests.
You can see that the second sample's readings are slightly higher, which is most likely why it fell noticeably behind at a 6 A discharge current.

After looking around online, I found that although it's unclear what these battery sizes are used for, they're available from quite a few stores under different brands. So it turns out this size isn't all that rare.
For comparison, here are four batteries: the two best-known sizes, 14500 (AA) and 18650, plus two "in-between" sizes, 14650 and 18500.

Conclusions.
These batteries left me with mixed feelings. On the one hand, they easily exceeded their rated capacity by a good margin: 1240 mAh versus 1100 mAh, and 4.5 Wh versus 4.1 Wh. On the other hand, in my opinion, their actual maximum continuous current is 4.5 A, 5 A at most—not the claimed 6 A, at which the batteries are clearly under heavy strain.
In short, discharge currents up to 3–4C are perfectly fine, but there's no point in drawing more than 5 A, and you shouldn't.
That's all for now. I hope this was useful.
$10.99 (лот 2шт)
This page was found when searching for:
https://www.kirich.blog/obzory/akkumulyatory/1011-akkumulyatory-vapcell-14650-v11-1100mah-6a, акумулятор 14650 в max-it.com, 14650 аккумулятор, 14650 аккумулятор аналог, аккумулятор 14650, 14650 аккумулятор размеры, v/14650
https://www.kirich.blog/obzory/akkumulyatory/1011-akkumulyatory-vapcell-14650-v11-1100mah-6a, акумулятор 14650 в max-it.com, 14650 аккумулятор, 14650 аккумулятор аналог, аккумулятор 14650, 14650 аккумулятор размеры, v/14650
Questions and answers
What capacity did the Vapcell 14650 V11 batteries deliver?
At a 0.2C discharge, the first cell delivered 1245 mAh, more than 10% above its rated 1100 mAh.
Can Vapcell 14650 V11 cells handle the rated 6 A?
At 6 A, a cell delivered just 807 mAh, which the author says indicates severe overload. The author recommends not exceeding about 4.5–5 A.
What discharge current is suitable for Vapcell 14650 V11?
The cells performed well up to 3–4C. The author advises against loading them above 5 A.
This model is included in the summary table: Battery comparison: measured capacity and resistance
The figures from this review are in the measurement database: Batteries
Calculate manuallyAll calculators
Discounted products
You may be interested in
Discounted products
Support the project
All the content on the site and the advice are free, but we’d be grateful for your support of the project and the channel!
Discuss on the forumHave a question or some experience to share? Discuss the article with the author and readers: the forum is a convenient place to share schematics and photos.
Go to the forumOnly registered readers can comment. It takes a minute to sign up, and you can log in with the same account you use on the forum.
Log inRegister



