/       /       /    Protected Liitokala 3400 mAh batteries, another batch
Support the project on Patreon


Protected Liitokala 3400 mAh batteries, another batch

$3.78 - 30.88
Go to store
A brief review of Liitokala 3400 mAh protected batteries.


This isn't my first review of batteries sold under this brand, so let's get straight to the point.
I ordered quite a few; these are among the batteries I order most often, both protected and unprotected.
They’re sold in lots of 1, 2, 3, 4, 5, 6, and 10. In this case, I ordered two lots of six for myself, plus some more for a friend.
The packaging was excellent: two packs of five and one pack of two. They were wrapped in two layers, then packed in a cardboard box.


They’re supposed to be Panasonic NCR18650B cells, but in reality there are two possibilities: either they’re repackaged used cells from some “Tesla,” or they’re from some Chinese manufacturer. So their service life will most likely be shorter, but they cost just $3 each.
These particular batteries are protected. You can see the conductive strip on the side connecting the positive terminal to the protection board, which is located near the negative terminal.
The markings are less clear than on the originals, and the positive terminal is a button top.


The protection board makes the batteries almost 70 mm long, so keep that in mind: they won’t fit in every device. I usually recommend them specifically because they’re protected, for flashlights, for example.
Here are the weights of the lightest and heaviest cells. The difference is very small, which is good.


My charger usually reports a capacity higher than the actual figure during testing, mainly because it slightly overcharges the cells, ending the charge at 4.22 V. With the rated capacity of 3400 mAh, it showed 3500–3600 mAh. Capacity was measured during discharge.


I connected the batteries to a proper electronic load and set the current to about 0.2C, which is 700 mA in this case.
Then I measured the capacity while discharging down to 3.0, 2.8, and 2.5 V.
Test results for batteries 1 and 2 (labeled above).

Battery 1
Down to 3.0 V — 3103 mAh or 11.27 Wh
Down to 2.8 V — 3257 mAh or 11.72 Wh
Down to 2.5 V — 3361 mAh or 12 Wh

Battery 2
Down to 3.0 V — 3082 mAh or 11.07 Wh
Down to 2.8 V — 3260 mAh or 11.6 Wh
Down to 2.5 V — 3379 mAh or 11.9 Wh

Neither cell reached the rated 3400 mAh, but the results are still pretty good. What’s more, the cells’ performance is very similar, which suggests a consistent manufacturing process.


Let’s load the first battery at 1C, or 3.4 A.
Down to 3.0 V — 2774 mAh or 9.48 Wh
Down to 2.8 V — 3032 mAh or 10.23 Wh
Down to 2.5 V — 3262 mAh or 10.84 Wh

The capacity in mAh barely changed, but the energy in Wh did drop. This is due to losses in the protection board.


Before the next test, I needed to check the protection cutoff current, so I set the load current to increase in steps to find the threshold.
It came out to 6.5 A, after which the protection kicked in.


Here I want to demonstrate the difference between a proper four-wire connection and a regular one. Above, the load was connected using the supplied alligator clips, which in turn have a proper four-wire connection to the load. At maximum current, the voltage dropped to 3.25–3.26 V.
Then I connected the battery using a special holder and got 3.54–3.55 V. In other words, about 0.3 V was being lost across various contacts, which would have introduced measurement error.
And that was without recharging the battery between tests; I simply ran the test again.
So we can conclude that the maximum current is 6.3–6.5 A.


Just to be safe, I set the current to 6 A, but the protection still cut off the battery during the test, after drawing about 1.1 Ah from it.


I recharged the battery and repeated the test at 5.5 A.
This time everything went well, and I got:
Down to 3.0 V — 2477 mAh or 8.29 Wh
Down to 2.8 V — 2933 mAh or 9.62 Wh
Down to 2.5 V — 3105 mAh or 10.1 Wh

In my opinion, that’s pretty good for what are effectively near-limit operating conditions.


In this mode, the protection cut off at about 2.67 V measured at the battery’s external terminals.


The 3.4 A test heated the battery to 42.5 °C. At 5.5 A, the temperature was noticeably higher, reaching 55 °C.


The conclusions are brief. These batteries are most likely not genuine, as the price suggests, but they work just fine and have a real, usable capacity. Besides, they're inexpensive and more than adequate for all kinds of flashlights and toys. Even if their service life is shorter, you're unlikely to notice. They also have built-in protection, which is useful in devices that don't have it.

That's all for now. I hope you found the review useful. I'm thinking about running some endurance tests, at least 200–300 full cycles.
$3.78 - 30.88
Go to store
This page was found when searching for:
нужно ли снимать прозрачную пленку с аккумулятора 18650, надо ли снимать плёнку с аккумулятора 1865, литокала убрать защиту, litokala есть ли защита, 4, есть ли в батарейках литокала защита от взрывов, https://www.kirich.blog/obzory/akkumulyatory/680-zaschischennye-akkumulyatory-liitokala-3400mach-esche-odna-partiya, liitokala 18650 есть ли защита от переразряда, защищенные аккумуляторы liitokala стоит ли брать, защищённый аккумулятор 18650 liitokala 3400mah, с акомулятора литокала 18650 надо снимать плёнку?, что будет если снять термоусадочную плёнку с аккумулятора 18650, liitokala срок годности, параметры аккумулятора литокала, аккумулятор литионные 18650 liitokala с защитой и без, аккумулятор liitokala 18650 защита от взрыва, liitokala 18650 защита, liitokala mh12210 нужно ли снимать термоусадочную пленку, liitokala с защитой и без, надо ли снимать пленку с батарейки liitokala, аккумуляторы liitokala с защитой, liitokala с защитой, нужно ли с аккумулятора снимать пленку с 18500, акумуляторы литокала и ихние приминения, снимать ли плёнку с батарейки 18650, аккумуляторы Liitokala, тест аккумуляторов, аккумуляторы 18650, 18650 аккумулятор 3400, тестирование аккумуляторов 18650

Questions and answers

What capacity did the protected Liitokala 3400 mAh cells actually deliver?

At a discharge current of about 700 mA, the two cells delivered 3082–3379 mAh, depending on the cutoff voltage: 3.0, 2.8, or 2.5 V. Neither reached the stated 3400 mAh.

At what current does protection trip on the Liitokala 3400 mAh cells?

The author estimated the trip threshold at 6.3–6.5 A. Protection cut off the cell during the 6 A test, while the 5.5 A test completed normally.

Are protected Liitokala 3400 mAh cells suitable for a flashlight?

The author recommends them for flashlights, among other uses, because built-in protection is useful in devices without their own. Their nearly 70 mm length means they will not fit every device.


This model is included in the summary table: Battery comparison: measured capacity and resistance

The figures from this review are in the measurement database: Batteries

Calculate manuallyAll calculators

Discounted products


You may be interested in


Discounted products


Support the project

All the content on the site and the advice are free, but we’d be grateful for your support of the project and the channel!

Discuss on the forumHave a question or some experience to share? Discuss the article with the author and readers: the forum is a convenient place to share schematics and photos.
Go to the forum

Only registered readers can comment. It takes a minute to sign up, and you can log in with the same account you use on the forum.

Log inRegister