/       /       /    High-current Samsung INR 18650-20S battery
Support the project on Patreon


High-current Samsung INR 18650-20S battery

By the luck of the draw—or, more precisely, thanks to my regular reader Alexey—I got my hands on another Samsung battery. It may not have a particularly high capacity, but it’s still very interesting, primarily because it’s designed for high-current applications such as e-cigarettes and power tools.

As I understand it, Alexey bought these for a cordless drill battery pack and had one cell left over. He sent it to me for testing, and I’m very grateful to him for that.


Yes, as I mentioned above, the capacity isn’t all that high—just 2000 mAh. Still, compared with the closest equivalent used by Milwaukee not long ago, the Samsung INR18650-15M with its 1500 mAh capacity, it’s not bad at all. The 15M is also rated for a maximum continuous current of 23 A, compared with 30 A for the 20S.
Link to the datasheet.


The most obvious difference is the color. I’ve mostly come across orange and green ones, but this one is blue, almost light blue.

The date code is marked the old-fashioned way, printed directly on the heat-shrink sleeve: 1HB4, which corresponds to late November 2017.
The first digit indicates the Samsung facility where the battery was manufactured.
The second letter indicates the year of manufacture: Q — 2008, S — 2009, Z — 2010, B — 2011, C — 2012, D — 2013, E — 2014, F — 2015, G — 2016, H — 2017, and so on.
The third letter or digit indicates the month of manufacture: 1 — January, 2 — February, 3 — March, 4 — April… A — October, B — November, C — December
The fourth digit indicates the week of manufacture, from the 1st to the 5th.

The manufacturing date is a bit old, but they were clearly bought some time ago.


The positive terminal has the standard three-prong design used on Samsung cells. The weight and dimensions are also as expected. By the way, I recently received four batteries for inspection, three of them Samsung cells. I may put together a little comparison of counterfeits and originals.


The manufacturer specifies an internal resistance of less than 15 mΩ for these batteries. In reality, it turned out to be half that, which is excellent. The specified resistance is for a fully charged battery, though my experience shows that any difference is minimal.


The first cycle was run in a secondary charger, with a charging current of 1 A and a discharge current of 0.5 A, which is close to the datasheet values of 0.5C and 0.2C. The battery delivered 2134 mAh, although this charger overestimates capacity, so I use it only for the first “conditioning” cycle.


Since this is a high-current battery, I used an EBC-A20 electronic load. Of course, the EBC-A40 would have been even better for this test; maybe I’ll splash out on one in the future.


The manufacturer specifies several discharge test conditions, with the primary one being a discharge at 0.2C, or 400 mA. The other results are given relative to this condition. The rated capacity is 1950 mAh, meaning the capacity of a new, genuine, fully functional battery.
Interestingly, the capacity at 10 A is the same as at 400 mA—100%. A reduction in capacity is allowed under the other test conditions.


At 0.2C, the battery delivered 2021 mAh. But what caught my attention wasn’t the capacity; it was the somewhat unusual discharge curve. The voltage drops very linearly down to 3.2–3.3 V, then falls sharply to the cutoff voltage of 2.5 V. This means:
1. The battery delivers most of its capacity in the range of roughly 3.2–4.2 V.
2. There’s no point discharging it below 3.0–3.2 V.
3. The battery’s energy output is slightly higher than that of cells with a more gradual voltage drop at the end, since most of the capacity is delivered at a higher voltage.


Here’s a more convenient comparison graph, with the colors corresponding to the test conditions:
Red — 0.2C — 400 mA
Orange — 0.5C — 1 A
Yellow — 1C — 2 A
Green — 5 A
Light blue — 10 A
Blue — 15 A
Purple — 20 A



Temperature readings at 10, 15, and 20 A. Check the readings near “Max.” I was a little late checking the 15 A test; I think the actual temperature was a couple of degrees higher.


The specifications also list a maximum continuous discharge current of 30 A, though this reduces the cycle life, so these operating conditions should be treated with caution.


Let’s get a more powerful electronic load, a four-wire battery holder, and a multimeter. The multimeter is needed to compensate accurately for the voltage drop across the wires between the holder and the electronic load. The compensation principle is very simple: apply a test current and note the difference between the voltage readings on the electronic load and the multimeter. In my case, it was about 0.67–0.68 V.


Instead of the original discharge cutoff voltage of 2.5 V, we’ll set it to 1.82 V (2.5 − 0.68) and run the test again.
The battery delivered 1990 mAh, which I think is a very good result.


During the test, the battery heated up to 84 degrees. That’s noticeably lower than the VTC5A batteries I showed recently, which went above 100, but keep in mind that:
1. There was a short pause while I reconfigured the load.
2. Because of its lower capacity, the test itself was 20% shorter. Even so, I think this battery performed better than the VTC5A.


In the comments on a review of one of the high-current batteries, someone asked me: what if you let the battery cool down and then start discharging it at 1C—how much more will it deliver?
Well, let’s find out. The battery delivered 1990 mAh at 30 A, then, after cooling down, another 16 mAh at 1C (2 A).


Since I had to recharge the battery many times during testing, I couldn’t help noticing how quickly it charges. It spends most of the time below 4.2 V, and once it reaches that voltage, the current drops quickly. So it takes about 2 hours and 1 minute to reach 1960 mAh.


I also tested charging at 1C and 2C; charging took about 65 and 38 minutes, respectively.


Well, friends, I think these batteries are simply excellent. The only slight disappointment is their capacity of just 2000 mAh, but everything else...
A sustained current of up to 30 A, moderate heating, just 7 mΩ of resistance, fast charging, a sharp voltage drop at the end of discharge and, consequently, good energy output in Wh. For example, the VTC5A delivers 7.911 Wh at a capacity of 2500 mAh and a current of 20 A; this battery delivers 6.815 Wh at 2000 mAh. So despite a 20% difference in capacity in mAh, the difference in capacity in Wh is 14%—and the VTC5A is also a genuinely good battery.

In short, I definitely recommend it.

That’s all. I hope you found this information useful.
This page was found when searching for:
18650 samsung 20r 20s, inr 18650-20r, проверка samsung inr 18650 20s, icr18650-20c sdi 7c1 samsung как расшифровать, inr18650-20s характеристики, samsung 18650 2000mah 30a, icr18650-20c характеристики, li 18650 20s, inr18650-20s, https://www.kirich.blog/obzory/akkumulyatory/756-vysokotokovyy-akkumulyator-samsung-inr-18650-20s, аккумулятор inr 18650 самсунг 20s, высокотоковый аккумуляторы самсунг, inr18650 20s kirich, высокотоковая батарея samsung, samsung inr18650 20s nikon, hh inr18650 даташит, аккумулятор 2000mah 3,6 inr18650 20s, аккумулятор inr18650 20s 2000mah 3.6в, samsung 18650 2000мач samsung inr18650 20r 3,6в 22a незащищенный li ion аккумулятор с выводами высокотоковый, icr18650 20s samsung характеристики, samsung inr 20s ток 30 a, in 8om, samsung tcr18650 20c, samsung icr18650 20, samsung icr18650-20, hvvea icr18650 20c характеристики, аккумуляторы samsung, литиевые аккумуляторы samsung, аккумуляторы 18650, тест аккумуляторов 18650, аккумуляторы 18650 samsung

Questions and answers

What capacity did the Samsung INR 18650-20S deliver?

It delivered 2021 mAh at a 0.2C discharge and 1990 mAh at 30 A.

What are the resistance and temperature of the Samsung INR 18650-20S under load?

Measured internal resistance was 7 mΩ. During a 30 A discharge, the cell reached 84 °C.

How quickly does the Samsung INR 18650-20S charge?

At a 1 A charge current, it took about 2 hours and 1 minute to take in 1960 mAh. Charging at 1C and 2C took about 65 and 38 minutes, respectively.


This model is included in the summary table: Battery comparison: measured capacity and resistance

The figures from this review are in the measurement database: Batteries

Calculate manuallyAll calculators

Discounted products


You may be interested in


Discounted products


Support the project

All the content on the site and the advice are free, but we’d be grateful for your support of the project and the channel!

Discuss on the forumHave a question or some experience to share? Discuss the article with the author and readers: the forum is a convenient place to share schematics and photos.
Go to the forum

Only registered readers can comment. It takes a minute to sign up, and you can log in with the same account you use on the forum.

Log inRegister