High-current Samsung INR21700-40T battery with a capacity of 4000 mAh and a rated current of 35 A
This is already my third review of batteries in this form factor. I’ve tested some kind of Litokala and a sibling of the one reviewed here, a Samsung, but with a capacity of 5000 mAh. This size is gradually gaining popularity, so I decided to test one as well.
It’s a little larger than the familiar 18650, with a diameter 3 mm greater and a length 5 mm greater. Below, it’s shown next to an 18650.

According to the datasheet, the battery has a capacity of 4000 mAh when discharged at 0.2C and 3900 mAh at 10 A. In both cases, discharge is cut off when the voltage drops to 2.5 V.
It also supports two charging modes: 2 A (0.5C) and 6 A (1.5C).

Based on the code 2IA2, the production date is mid-October 2018. There are also additional alphanumeric markings under the heat-shrink sleeve, most likely production codes.

21700 batteries are about one and a half times heavier than their 18650 counterparts.

As before, the batteries went through a “conditioning” charge/discharge/charge cycle, with capacity measured during discharge to 2.8 V at 0.5 A. The process took a very long time, but in the end I got my first measured result: about 4200 mAh.

I then used two electronic loads: a ZKE EBC-A10H as the charger and a ZKE EBC-A20 for measurements.
As mentioned above, the battery can be charged at either 2 A or 6 A. Of course, all the values in between are supported too, but these are the two specified as key charging rates. The first is the standard rate, the second is the fast rate.

Unfortunately, both loads can charge at a maximum of only 5 A, so I could test only at 2 A and 5 A.
In standard mode, charging took 2 hours and 13 minutes, which is pretty good in my opinion. The current drops off sharply at the end of charging, which speeds things up because the process runs at full current for most of the time.

At a charging current of 5 A, the current takes longer to taper off, but the battery can still realistically be charged in about an hour at this rate. At 6 A, it should be a little faster.

Although the store page lists a maximum discharge current of 35 A, the datasheet gives figures for a discharge current of 40 A. The reason is that continuous discharge at 35 A is specified without a temperature cutoff, while up to 45 A (yes, exactly 45—that’s an odd one) is allowed with cutoff at 80 degrees.

I ran 7 tests at different currents:
0.2C - 800 mA
0.5C - 2 A
1C - 4 A
2C - 8 A
3C - 12 A
4C - 16 A
5C - 20 A
I used a slightly unusual set of test points to make the current thresholds easier to compare, since I usually test at 2C. For this battery, the difference between 2C (8 A) and 10 A was very small.
In the end, I got 4070 mAh at 0.2C and 3896 mAh at 12 A (3C), which matches the datasheet figures. The result at 10 A can be estimated as the average of the 2C and 3C results: (3917+3896)/2=3906 mAh.

The battery barely heated up: even at 20 A, its temperature reached only 75 degrees.
Temperature during discharge at 12, 16 and 20 A.

The second battery gave a result only slightly lower than the first, well within the measurement error.

Its temperature was actually a little lower, in all three modes.

Next, I moved on to a more serious load: 30 A, using a different device.

The test procedure is standard: the multimeter measures the voltage at the battery terminals, while the load is connected through the power terminals. I measure the voltage drop under load and adjust the discharge cutoff voltage accordingly.
The results were 3885 and 3851 mAh for the first and second batteries, respectively.

This load can’t generate graphs—or rather, its software doesn’t work for me—so I decided to do things a little differently and use the multimeter that measured the voltage to plot the graph. The screenshot shows that I wasn't far off with the voltage correction: cutoff occurred at 2.52 V, compared with the calculated 2.5 V.

Even under these conditions, though, the temperature barely exceeded 95 degrees, and the second battery was once again a little cooler.

This is all very interesting, of course, but the battery can take more—especially since I hadn't even reached 100 degrees.
So I had to bring out an even higher-current load. I was going to call it a more powerful one, but that's not quite right: it can dissipate a maximum of 300 W, but its maximum current is up to 40 A.

This time I used a different method to monitor the voltage: I simply watched it on the multimeter and switched off the load manually.
Unfortunately, due to the large voltage drop across the contacts, wires, shunt, and so on, I could only get 37 A from a fully charged battery. By the end of the discharge it was even below 30 A, but in any case, the average discharge current was clearly higher than in the previous measurement.
The result was about 3893 mAh, although the measurement accuracy here isn't very high. The subsequent charge took 3819 mAh, so I think getting around 3800 mAh out of the battery is entirely realistic (the charge/discharge difference in mAh is very small for lithium batteries).

Here I did get above 100 degrees. By the way, the second photo shows that the load terminals also got noticeably hot. They're quite well made, but even they struggle with 40 A.

Internal resistance in three measurements:
1. As received, before any tests
2. After the "conditioning" cycle
3. After all the tests.

And of course, we need some comparisons. First, let's see how this battery stacks up against the VTC5D, which is also a high-current cell and has the highest capacity available in the 18650 form factor.
You can see that "size matters": the extra 3 mm in diameter and 5 mm in length gave it a noticeable capacity boost.

And as a "bonus," here's a comparison of two 21700 batteries: a high-current one and the high-capacity INR21700-50E.
This comparison is just for reference, since these are batteries from different classes. If I'd tried to load the INR21700-50E with the same currents I used on the INR21700-40T, it would most likely have ended badly for the former.

I'll keep the conclusions brief: these batteries can really handle 30–35 A, and can easily take 40 A for short periods. That makes them a great fit for power-tool battery packs, replacing a couple of cells like the VTC5 or VTC5A. It's not a completely like-for-like replacement, but it's very close, with a slight loss in capacity. For example, a pair of VTC5A cells will give you about 4800 mAh; here you'll get 3800, but you'll need half as many cells.
That's all from me. Thanks for stopping by to read :)
samsung inr21700 t-40 цикл зарядки, kirich samsung 21700 40t, https://www.kirich.blog/obzory/akkumulyatory/772-vysokotokovyy-akkumulyator-samsung-inr21700-40t-emkostyu-4000mach-i-zayavlennym-tokom-35a, 18650 аккумулятор самсунг синий, батарея 21700 самсунг 40т, samsung 27000 40t внутреннее сопротивление, аккумулятор samsung 40т 21700 4000mah 30а, аккумулятор inr21700 40t li ion 4000mah 30 a высокотоковый большой емкости, samsung 40t сколько вольт отдаёт, samsung inr21700 40t 40t3 4000mah 35a, аккумулятор 21700 высокотоковый samsung 40t, акб самсунг 40 т из чего состоит, inr21700 40t и samsung 21700 30t, 2170 40 т samsung с платой защиты, samsung 40 t 21700, samsung 21700 30t vs 2170040t, samsung 40t аккумулятор, 40т 3.7 v 4000mah, samsung 21700 40t вольтаж, samsung inr21700-30t, samsung 21700 ток разряда, акб 21700 samsung 40 t, samsung 21700 40t на мехмоде, аккумулятор samsung inr 21700 72w/h для электроинструмента характеристики, акб самсунг т40 обзор
Questions and answers
What capacity did the Samsung INR21700-40T deliver in the discharge tests?
It measured 4070 mAh at 800 mA and 3896 mAh at 12 A. The estimate at an average current above 30 A was about 3800 mAh.
What discharge current can the Samsung INR21700-40T handle?
The author concludes that it handles 30–35 A continuously and can take 40 A briefly.
How long does it take to charge the Samsung INR21700-40T?
Charging at 2 A took 2 hours 13 minutes. At 5 A, charging took about an hour; the test equipment could not check the specified 6 A mode.
This model is included in the summary table: Battery comparison: measured capacity and resistance
The figures from this review are in the measurement database: Batteries
Discounted products
You may be interested in
Discounted products
All the content on the site and the advice are free, but we’d be grateful for your support of the project and the channel!
Only registered readers can comment. It takes a minute to sign up, and you can log in with the same account you use on the forum.
Log inRegister


