/       /    Pocket P1, a mini computer about the size of a smartphone.
Support the project on Patreon


Pocket P1, a mini computer about the size of a smartphone.

$116.99
Go to store
I've already written about a mini computer running Windows 8.1
This computer is very similar, but it also has some noticeable differences, mostly for the better. Nothing is perfect, though, and I'll try to cover that in this review.
I'll say right away: there will be a teardown :)

Someone mentioned in one of the comments that, at this rate, we'll soon have smartphones with an Atom processor and Windows on board.
As for using that combination in a smartphone, I have serious doubts about whether it makes sense. But in terms of size, computers comparable to smartphones have already appeared.
This review is about one of them.

I don't expect any differences in performance, since it uses the same platform as other similar devices, but I'll run some tests anyway.
The main difference with this computer is its design.

First, a few photos of the packaging, but I'll tuck them under a spoiler.
The packaging itself looked pretty good, though.

The box was divided into two “levels”: the computer on top, and the rest of the kit underneath.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

The package includes:
1. Mini computer
2. Micro HDMI to HDMI cable
3. Micro USB to USB cable
4. Power supply
5. Manual.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.


And here he is in all his glory.
First, the specs:
Processor — Intel Baytrail T Z3735F
Graphics — Intel HD Graphic
RAM — 2 GB
Flash storage — 32 GB (I wish it had 64, but that's still pretty rare)
Micro SD card slot, supports up to 32 GB
WiFi — IEEE 802.11 b/g/n
Bluetooth: Bluetooth 4.0
Battery — 2 × 1500 mAh, 3.7 V
Connectors — HDMI, 2xUSB, 1x micro USB, 3.5 mm audio
Dimensions — 152 x 83 x 11.4 mm
Weight — 227 g

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

The case is silver-colored and made of aluminum.
The top has the logos of the manufacturer, Beelink, and the processor maker, Intel.
The power supply voltage and current draw are also printed on top. That's unusual; they're normally listed on the back or bottom.
Protective films are stuck to the front and back panels. I removed them later, but you can still see them in these photos—or rather, the little tabs for peeling them off.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

There's nothing on the bottom at all, apart from a sticker with the serial number.
It doesn't even have feet.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

Here are photos without the protective films.
To be honest, I don't like the word “stylish,” but in this case it describes the look perfectly.
There's nothing on the front panel—not even an indicator LED (which is a big plus). It's just a simple black panel, and it really does look great. I love minimalist tech design, and the manufacturer has absolutely nailed it here.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

The rear panel is the complete opposite of the front: every bit of it is occupied.
In order:
USB port
Power/sleep indicator LED. I didn't even notice it at first.
Second USB port
Micro USB port, used to power the device. When running on battery, this is a full-fledged USB port. I don't have a Y-cable, but I think you can power the device and use this as a regular port at the same time.
Micro HDMI port
Micro SD card slot (that's the third “micro” in the description of the rear panel)
3.5 mm jack for audio output and microphone.
Power button.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

As I mentioned in the description, it's about 15 cm long.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

I couldn't resist taking apart such an interesting device, but this time I decided to avoid the mistake I made with the PIPO X7. I waited until after all the tests to take it apart; the key thing I wanted to test was how hot the device got (everyone remembers the sticking point with the Pipo).
And as an engineer, it's easier for me to judge a device's quality by how it's put together.

The teardown above showed no issues with the assembly or design. Heat is transferred very effectively from the processor and power controller to the aluminum case. I was also impressed by the high-quality, well-thought-out assembly. The teardown wasn’t very convenient, though, but I hope my instructions will be useful. It would be easier to take apart now; the main thing is to keep dust off the double-sided tape, or you’ll have to replace it.
When reassembling it, just to be safe, I applied KPT-8 thermal paste to the shielding cover, but didn’t notice any difference.
By the way, during disassembly I noticed that this whole “sandwich” fits very tightly in the case, and you’ll need to apply some force to push it out. Apparently, that’s what keeps the processor pressed firmly against the case. I like it.

Next up are tests with various programs and a look at the software features of this mini computer.
As I mentioned above, this time I ran all the tests first and only then took the device apart.
I did this to get more accurate test results.


After switching the system to Russian, I disabled the tiles that annoyed me.
Or rather, I didn’t disable them; I just enabled the mode that boots straight to the desktop, bypassing them.

Pocket P1, a mini computer about the size of a smartphone.

The only preinstalled software on the computer was PCRemoteServer, which I removed without a second thought.
I also somehow accidentally installed Lenovo’s SHAREit in the process. I have no idea how I did that, but since I don’t own anything from Lenovo, I removed that too. I didn’t find anything else unnecessary.
Finally, for convenience, I installed Classic Shell. Working with Windows 8 isn’t quite comfortable for me without it.

After all that, I moved on to the actual testing.
As usual, I started with the WinRAR performance test I’m familiar with.
The result is, of course, similar to that of other devices with this processor (it would be surprising if it were noticeably different).

Pocket P1, a mini computer about the size of a smartphone.

Then I ran the test in 7-ZIP and got an even higher result than the PIPO X7 (which scored 3874), even though it uses a processor with a higher turbo frequency. This further confirms my suspicion that the processor rarely reaches its maximum frequency, and only briefly, running under load mostly at around 1.55 GHz.

Pocket P1, a mini computer about the size of a smartphone.

CrystalDiskMark test
The result is a little better than the PIPO’s, but not by much.

Pocket P1, a mini computer about the size of a smartphone.

The 3DMark result is practically identical to the PIPO’s.
While testing, I also monitored the processor temperature. The highest reading I got was 71 degrees. Temperatures were lower in the other tests, so I won’t list them.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

CPU-Z didn’t provide any new information. It feels like this is the same computer, though technically, it is.

Pocket P1, a mini computer about the size of a smartphone.

Even the BIOS is the same, from the same manufacturer. I thought there might be even more settings this time, but I can’t say for sure.

Pocket P1, a mini computer about the size of a smartphone.

CineBench is a more familiar test for me. The screenshot shows a repeat run; the previous result is in the lower-left column. I ran the test again to measure the temperature under load.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

Memory test in AIDA64.

Pocket P1, a mini computer about the size of a smartphone.

Testing the flash drive with HD Tune Pro, a popular hard drive testing program.

Pocket P1, a mini computer about the size of a smartphone.

Since the device has a battery, I naturally tested its battery life.
I ran the test in two scenarios.
1. Playing a 1080p movie, with a wired mouse, keyboard, and flash drive connected to the computer (the movies were played from the drive), and Wi-Fi connected.
2. The same setup, but playing a 720p movie.
I also monitored CPU load and temperature.
For both tests, I first charged the battery to 99% (for some reason, it won't charge to 100%). The computer shut down at 6%.

In the first test, the computer ran for 2 hours and 15 minutes.
In the second test, it lasted a little longer: 3 hours and 25 minutes. The CPU load was lower, at around 20–25%.
A full charge takes about 3.5 hours.
I also noticed that playing Full HD video from YouTube puts a much lighter load on the CPU, at around 20%.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

I noticed a USB 3.0 controller and a UART controller in Device Manager. They don't show up anywhere else, which is a shame :(

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.

And finally, here's a photo of the test in progress. WiFiInfoView is running on the computer and has found 25 access points.

Pocket P1, a mini computer about the size of a smartphone.Pocket P1, a mini computer about the size of a smartphone.


Summary:
Pros
Small size
Low heat output, which is especially nice given its compact size.
Quite fast for such a small device.
Built-in battery (more on that below)
Attractive design and good build quality.

Cons
I really wish it had USB 3.0—not inside, but on the outside :)
I was a little disappointed that it can't connect via Ethernet, though with dimensions like these, there wouldn't have been room for a port anyway.

My take: I really liked this computer. I wouldn't call it perfect, but I was pleasantly surprised by the design and especially by how cool it runs. Under full load, the case reached about 45 degrees, which I think is a good result.
I'm surprised manufacturers don't put USB 3.0 in these computers. In my opinion, that significantly limits what the device can do. And as I mentioned in the summary, I also miss the option of connecting via a regular Ethernet cable. Wi-Fi is great, of course, but a cable feels more familiar and reliable.
I'm not entirely sure why this device has a battery. If there's a TV or monitor, there's usually an outlet too; and where there isn't an outlet, there's nowhere to plug in a monitor either. But maybe I'm wrong, and it really is useful. For me, the battery is handy because I don't need a UPS when using the computer at home or in the office. In that scenario, it's a plus.
It looks good, with nothing unnecessary.

I bought the computer from gearbest, at a substantial discount.

In my previous review of a similar device, I mentioned that I was planning to buy a few of them. But I wanted something new, so I chose this one. I think I made the right choice.

I hope this review helps you choose a mini computer.
There's currently a discount when you use the P1 coupon. The price will then be about $99.
$116.99
Go to store
This page was found when searching for:
byt-p1 маленький комп, raydget.ru мини пк, компьютер выглядит как смартфон, мини компьютеры размером с о смартфонах, компьютер выглядящий как смартфон, компьютер величиной со смартфон, beelink pocket p1 купить, что такое компьютер размером со смартфон, мини пк с размером смартфона, pocket p1. отзывы, p_1 v kampyuter, смартфон размером с компьютер, компьютер размером со смартфон, мини пк с размером со смартфон

Questions and answers

What are the Beelink Pocket P1 mini PC’s specifications?

It has an Intel Baytrail T Z3735F, 2 GB of RAM and 32 GB of flash storage, plus Wi-Fi, Bluetooth 4.0, two USB ports, Micro HDMI and a 2×1500 mAh battery.

How hot does the Beelink Pocket P1 get under load?

The author measured the case at about 45 °C under full load. The power adapter reached about 40 °C in operation and made a faint buzzing sound.

What drawbacks did the author find in the Pocket P1?

The author wanted an external USB 3.0 port and a way to connect a standard LAN cable. He also questioned the usefulness of the built-in battery, though he saw it as a benefit when using the PC without a UPS.

The figures from this review are in the measurement database: Other devices


Discounted products


You may be interested in


Discounted products


Support the project

All the content on the site and the advice are free, but we’d be grateful for your support of the project and the channel!

Discuss on the forumHave a question or some experience to share? Discuss the article with the author and readers: the forum is a convenient place to share schematics and photos.
Go to the forum

Only registered readers can comment. It takes a minute to sign up, and you can log in with the same account you use on the forum.

Log inRegister